GermanyUSACanadaUKFranceEspanaItaliaNederlandsIndiaJapanChina
Logo France

S’inscrire | Connexion 

Huawei E173 (Clé 3G, USB 2.0)

Réseau EDGE, GSM, HSDPA, HSUPA, Huawei, Clé 3G / 4G, Clé 3G / 4G, USB

Huawei E173 (Clé 3G, USB 2.0)
Examen de compatibilité avec Linux: Seule la compatibilité Linux est évalué sur cette page, pas la qualité générale du produit. Si vous utilisez ce produit avec Linux, s'il vous plaît noter et partager votre expérience dans la zone commentaire de cette page (en bas) pour soutenir d'autres utilisateurs de Linux.
3 évaluations, en myoenne: 4,3 de 53 évaluations, en myoenne: 4,3 de 53 évaluations, en myoenne: 4,3 de 53 évaluations, en myoenne: 4,3 de 53 évaluations, en myoenne: 4,3 de 5
  ( 4.3 avec 3 évaluations)


courbe de prix
Huawei E173 
-
Minimum: EUR 20,90 
Maximum: EUR 64,65  
Mis à jour: 26/05/2016 17:20

Examen de compatibilité avec Linux

The Huawei E173 is a USB surfstick, that supports mobile internet connections per GSM, GPRS, EDGE, UMTS, HSDPA, and HSUPA.

Depending on the model version and the modus of the surfstick (i.e. USB storage device mode or surfstick modue) several USB IDs have already been identified:

Bus 001 Device 003: ID 12d1:1d35 Huawei Technologies Co., Ltd.
Bus 002 Device 004: ID 12d1:1c05 Huawei Technologies Co., Ltd.
Bus 002 Device 011: ID 12d1:1c0b Huawei Technologies Co., Ltd.
Bus 002 Device 002: ID 12d1:1446 Huawei Technologies Co., Ltd.

The E173 is fully and automatically supported under Ubuntu 12.04. On can configure the internet connection in the menu « New Mobile Broadband Connection ».

In other distributionen several configuration steps might be necessary to switch the stick into surf modusand to establish the internet connection.

If the switching of the USB sticks into surf mode by usb_modeswitch is not configured correctly, the stick will only be initialized as a USB storage device. In this case the following log messages can be seen:

usb 1-3: new high speed USB device using ehci_hcd and address 3
scsi4 : usb-storage 1-3:1.0
scsi5 : usb-storage 1-3:1.1
scsi 4:0:0:0: CD-ROM HUAWEI Mass Storage 2.31 PQ: 0 ANSI: 2
scsi 5:0:0:0: Direct-Access HUAWEI SD Storage 2.31 PQ: 0 ANSI: 2
sr0: scsi-1 drive
sr 4:0:0:0: Attached scsi generic sg1 type 5
sd 5:0:0:0: Attached scsi generic sg2 type 0
sd 5:0:0:0: [sdb] Attached SCSI removable disk
usb 1-3: USB disconnect, address 3
usb 1-3: new high speed USB device using ehci_hcd and address 4
scsi6 : usb-storage 1-3:1.0
scsi7 : usb-storage 1-3:1.1
scsi 7:0:0:0: Direct-Access HUAWEI SD Storage 2.31 PQ: 0 ANSI: 2
scsi 6:0:0:0: CD-ROM HUAWEI Mass Storage 2.31 PQ: 0 ANSI: 2
sr0: scsi-1 drive
sr 6:0:0:0: Attached scsi generic sg1 type 5
sd 7:0:0:0: Attached scsi generic sg2 type 0
sd 7:0:0:0: [sdb] Attached SCSI removable disk

The switching of the stick into sorf mode is carried out by the program usb-modeswitch, which has to be installed on the Linux distribution:

apt-get install usb-modeswitch usb-modeswitch-data

The switching of the sticks is performed automatically (if the distribution is configured in this way), or has to be done with the following command

usb_modeswitch -Hc "/etc/usb_modeswitch.d/12d1:1c0b"

If configured correctly, the switching into surf modue is shown by the following kernel messages:

usb 2-1: usbfs: process 6076 (usb_modeswitch) did not claim interface 0 before use
usb 2-1: USB disconnect, address 13
usb 2-1: new high speed USB device using ehci_hcd and address 14
usb 2-1: New USB device found, idVendor=12d1, idProduct=1c05
usb 2-1: New USB device strings: Mfr=2, Product=1, SerialNumber=0
usb 2-1: Product: HUAWEI Mobile
usb 2-1: Manufacturer: HUAWEI
usb 2-1: configuration #1 chosen from 1 choice

The connection to the internet is carried out by the interfaces ttyUSB0, ttyUSB1, and ttyUSB2. These simulate a classical modem device. The devices are created by the programm usbserial, which has to be configured for the E173, e.g. by the following entry in the file /etc/modules

usbserial vendor=0x12d1 product=0x1c05

A configuration file has to be created in the folder /etc/usb_modeswitch.d to achieve an automatic switching of the stick, e.g.

########################################################
# Huawei E173s

DefaultVendor= 0x12d1
DefaultProduct= 0x1c0b

TargetVendor= 0x12d1
TargetProduct= 0x1c05

CheckSuccess=20

MessageEndpoint= 0x0f
MessageContent= "55534243123456780000000000000011062000000100000000000000000000"

Furthermore, a udev rule has to be defined, which is executed automatically if the stick is plugged in. This udev rule will execute modeswitch with the necessary command option and is configured by /lib/udev/rules.d/40-usb_modeswitch.rules:

#Huawei E173s
ATTRS{idVendor}=="12d1", ATTRS{idProduct}=="1c0b", RUN+="usb_modeswitch '%b/%k'"

Matériel Linux Similaire

scroll left scroll right

 Commentaires

Utilisez la section commentaires pour nous suggérer des corrections de l'article et des sorties de commandes lspci -vnn, lsusb, lshw, dmesg, etc...
De plus, vous pouvez utiliser les commentaires pour nous communiquer vos expériences avec le matériel ou pour rechercher de l'aide pour la configuration.
 

L'adresse email n'est pas rendue publique.

Notez la compatibilité avec Linux


Tags HTML et attributes disponible : <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>


Types de fichiers autorisés : txt, jpg, png, gif, taille maximale de fichiers : 2MB.