GermanyUSACanadaUKFranceEspanaItaliaNederlandsIndiaJapanChina
Logo España

Registrarse | Iniciar sesión 

Huawei E173 (Surfstick, USB 2.0)

Red EDGE, GSM, HSDPA, HSUPA, Huawei, Surfstick, UMTS / GSM / HSDPA, USB

Huawei E173 (Surfstick, USB 2.0)
Compatibilidad con Linux: En esta página sólo se evalúa la compatibilidad con Linux del producto, no la calidad general del mismo.Si utiliza este producto con Linux, por favor evalúelo y comparta sus experiencias en la sección de comentarios al final de esta página para apoyar así a otros usarios de Linux.
3 votos, media: 4,3 sobre un total de 53 votos, media: 4,3 sobre un total de 53 votos, media: 4,3 sobre un total de 53 votos, media: 4,3 sobre un total de 53 votos, media: 4,3 sobre un total de 5
  ( 4.3 con 3 valoraciones)


Tendencia del precio
Huawei E173 
-
Minimum: EUR 19,89 
Maximum: EUR 64,65  
Actualizado: 26/05/2016 17:20

Revisión de Compatibilidad con Linux

The Huawei E173 is a USB surfstick, that supports mobile internet connections per GSM, GPRS, EDGE, UMTS, HSDPA, and HSUPA.

Depending on the model version and the modus of the surfstick (i.e. USB storage device mode or surfstick modue) several USB IDs have already been identified:

Bus 001 Device 003: ID 12d1:1d35 Huawei Technologies Co., Ltd.
Bus 002 Device 004: ID 12d1:1c05 Huawei Technologies Co., Ltd.
Bus 002 Device 011: ID 12d1:1c0b Huawei Technologies Co., Ltd.
Bus 002 Device 002: ID 12d1:1446 Huawei Technologies Co., Ltd.

The E173 is fully and automatically supported under Ubuntu 12.04. On can configure the internet connection in the menu “New Mobile Broadband Connection”.

In other distributionen several configuration steps might be necessary to switch the stick into surf modusand to establish the internet connection.

If the switching of the USB sticks into surf mode by usb_modeswitch is not configured correctly, the stick will only be initialized as a USB storage device. In this case the following log messages can be seen:

usb 1-3: new high speed USB device using ehci_hcd and address 3
scsi4 : usb-storage 1-3:1.0
scsi5 : usb-storage 1-3:1.1
scsi 4:0:0:0: CD-ROM HUAWEI Mass Storage 2.31 PQ: 0 ANSI: 2
scsi 5:0:0:0: Direct-Access HUAWEI SD Storage 2.31 PQ: 0 ANSI: 2
sr0: scsi-1 drive
sr 4:0:0:0: Attached scsi generic sg1 type 5
sd 5:0:0:0: Attached scsi generic sg2 type 0
sd 5:0:0:0: [sdb] Attached SCSI removable disk
usb 1-3: USB disconnect, address 3
usb 1-3: new high speed USB device using ehci_hcd and address 4
scsi6 : usb-storage 1-3:1.0
scsi7 : usb-storage 1-3:1.1
scsi 7:0:0:0: Direct-Access HUAWEI SD Storage 2.31 PQ: 0 ANSI: 2
scsi 6:0:0:0: CD-ROM HUAWEI Mass Storage 2.31 PQ: 0 ANSI: 2
sr0: scsi-1 drive
sr 6:0:0:0: Attached scsi generic sg1 type 5
sd 7:0:0:0: Attached scsi generic sg2 type 0
sd 7:0:0:0: [sdb] Attached SCSI removable disk

The switching of the stick into sorf mode is carried out by the program usb-modeswitch, which has to be installed on the Linux distribution:

apt-get install usb-modeswitch usb-modeswitch-data

The switching of the sticks is performed automatically (if the distribution is configured in this way), or has to be done with the following command

usb_modeswitch -Hc "/etc/usb_modeswitch.d/12d1:1c0b"

If configured correctly, the switching into surf modue is shown by the following kernel messages:

usb 2-1: usbfs: process 6076 (usb_modeswitch) did not claim interface 0 before use
usb 2-1: USB disconnect, address 13
usb 2-1: new high speed USB device using ehci_hcd and address 14
usb 2-1: New USB device found, idVendor=12d1, idProduct=1c05
usb 2-1: New USB device strings: Mfr=2, Product=1, SerialNumber=0
usb 2-1: Product: HUAWEI Mobile
usb 2-1: Manufacturer: HUAWEI
usb 2-1: configuration #1 chosen from 1 choice

The connection to the internet is carried out by the interfaces ttyUSB0, ttyUSB1, and ttyUSB2. These simulate a classical modem device. The devices are created by the programm usbserial, which has to be configured for the E173, e.g. by the following entry in the file /etc/modules

usbserial vendor=0x12d1 product=0x1c05

A configuration file has to be created in the folder /etc/usb_modeswitch.d to achieve an automatic switching of the stick, e.g.

########################################################
# Huawei E173s

DefaultVendor= 0x12d1
DefaultProduct= 0x1c0b

TargetVendor= 0x12d1
TargetProduct= 0x1c05

CheckSuccess=20

MessageEndpoint= 0x0f
MessageContent= "55534243123456780000000000000011062000000100000000000000000000"

Furthermore, a udev rule has to be defined, which is executed automatically if the stick is plugged in. This udev rule will execute modeswitch with the necessary command option and is configured by /lib/udev/rules.d/40-usb_modeswitch.rules:

#Huawei E173s
ATTRS{idVendor}=="12d1", ATTRS{idProduct}=="1c0b", RUN+="usb_modeswitch '%b/%k'"

Hardware de Linux similares

scroll left scroll right

 Commentarios

Por favor, emplee la sección de comentarios para indicar correciones del artículo así como extractos de lspci, lsusb, lshw, dmesg etc. Además, utilice la sección para el intercambio de experiencias con este componente de hardware o para obtener ayuda para la configuración de otros propietarios de este mismo hardware.
 

La dirección de correo electrónico no será publicada

Evaluar la compatibilidad con Linux


Use los siguientes etiquetas y atributos HTML:: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>


Tipos de archivo permitidos: txt, jpg, png, gif, tamaño máximo de archivo: 2MB.